"Patina" The 1973 CB175 Cafe Racer

Re: "Patina" The 1973 CB175 Cafe Racer

Want me to tell you where on the crankshaft it sparks?
 
Re: "Patina" The 1973 CB175 Cafe Racer

1sttimer said:
Want me to tell you where on the crankshaft it sparks?
On top of the piston.... Mix some air.... Oh wait we need fuel...damn it batman
 
Re: "Patina" The 1973 CB175 Cafe Racer

Fuel in the bowl, ignition on, tested for spark. Here we go.
 
Re: "Patina" The 1973 CB175 Cafe Racer

Took three pushes, fired right up and went right to the redline. Air screw?
 
Re: "Patina" The 1973 CB175 Cafe Racer

1sttimer said:
Took three pushes, fired right up and went right to the redline. Air screw?
Are both slides working
What's your air screw adjusted at, from seat
 
Re: "Patina" The 1973 CB175 Cafe Racer


cafe mike said:
Are both slides working
What's your air screw adjusted at, from seat

Is air screw the protruding screw or the recessed screw.

I set both at 1.5 turns out
 
Re: "Patina" The 1973 CB175 Cafe Racer

1sttimer said:
Is air screw the protruding screw or the recessed screw.

I set both at 1.5 turns out
That's why! One is your air screw. The other adjusts the slide up and down. Back out the middle one!
Air screw is recessed
 
Re: "Patina" The 1973 CB175 Cafe Racer


cafe mike said:
That's why! One is your air screw. The other adjusts the slide up and down. Back out the middle one!
Air screw is recessed

Middle one? There's only two.
 
Re: "Patina" The 1973 CB175 Cafe Racer


cafe mike said:
Take off your filters and make sure your slides are going all the way down and up at the same time

Yeah checked that.
 
Re: "Patina" The 1973 CB175 Cafe Racer

1sttimer said:
Middle one? There's only two.
Yeah the one near the middle
 

Attachments

  • image.jpg
    image.jpg
    231.1 KB · Views: 311
Re: "Patina" The 1973 CB175 Cafe Racer


cafe mike said:
Now as you back that off. Make sure it's dropping down and you don't have your cables too tight

One throttle cable end came out of the brass nipple and pulled the slide up. I screwed it all the way in, and they both rest at the same height.

Now how far do I back it out from bottom?
 
Re: "Patina" The 1973 CB175 Cafe Racer

1sttimer said:
One throttle cable end came out of the brass nipple and pulled the slide up. I screwed it all the way in, and they both rest at the same height.

Now how far do I back it out from bottom?

Did you turn the idle screw out yet?
 
Back
Top Bottom