NoRiders
Over 1,000 Posts
Hi all, blimey was my last post back in July??
I've been back working so found very little time to get into the garage...life getting in the way etc.
Anyhoo...a small task has been set in motion. The Microns attach by way of a spigot that is bolted to the barrel, the pipes then slide onto the spigot and held in place by exhaust springs...check.
To have the Microns sit/position correctly along the bike I had to extend the spigots by approx 50-60mm and give them a slight 15* bend to align with the Micron downpipe fitting.
I had bodged a short pipe to the existing spigot with a zorst clamp, which proved the concept and requirement.
You can see what I'd done in the image.
I've now spoken to a stainless exhaust specialist....just around the corner from me..yay, and he's going to make the one piece spigot and provide new 2xbolt flanges to suit. It'll look a whole lot neater when the fella's finished.
So that's my news...
I've been back working so found very little time to get into the garage...life getting in the way etc.
Anyhoo...a small task has been set in motion. The Microns attach by way of a spigot that is bolted to the barrel, the pipes then slide onto the spigot and held in place by exhaust springs...check.
To have the Microns sit/position correctly along the bike I had to extend the spigots by approx 50-60mm and give them a slight 15* bend to align with the Micron downpipe fitting.
I had bodged a short pipe to the existing spigot with a zorst clamp, which proved the concept and requirement.
You can see what I'd done in the image.
I've now spoken to a stainless exhaust specialist....just around the corner from me..yay, and he's going to make the one piece spigot and provide new 2xbolt flanges to suit. It'll look a whole lot neater when the fella's finished.
So that's my news...