Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
We noticed you are blocking ads. DO THE TON only works with community supporters. Most are active members of the site with small businesses. Please consider disabling your ad blocking tool and checking out the businesses that help keep our site up and free.
Got excess pressure building up in the tank after a few minutes of riding due to a clogged vent. Tried soaking in vinegar and blowing compressed air to no avail. Anyone know how to disassemble this little f*cker? I've seen ones with a screw on the bottom, but this one has no slotted screw. Would...
So I was wondering if there was any way short of tearing open the engine to see that oil is getting to the top end of my cl360. I know oiling issues are common on these motors.
I've recently had my carbs worked on by PJ, and she fired right up and ran better than ever. I played with the idle...
Hey guys,
Figured it's finally time to post a thread on all the work i've done to this little bike over the past year.
Going into this project I had little to no experience with engines and wiring. All I knew is that the best way to start was to dive in and get my hands dirty. You can read all...
Hey guys, unsurprisingly I've been battling some charging issues on my CL360. Went for a decent length ride around town and everything ran great but came back home to a battery down to ~7V. I checked the stator impedance and i'm reading 2.0, 3.0 and 2.5 ohms across plug wires and no grounding...
Hey guys,
I got my cafe project on the road with a lot of help from you guys, and after a few short runs on her, i was experiencing some battery issues. I'm running a Ballistic EVO2 4 Cell battery with a Kohler R/R (2575503S 4140305 4140309) on a '75 CL360.
My first Ballistic battery quit on...
Hey guys, I have completed my 75 cl360 cafe racer project in all aspects except for one. The clutch won't budge!
During the build, I replaced the clutch springs with heavy duty ones, and also replaced the clutch cable and adjustment screw. I've adjusted and adjusted according to manual specs...
Hey guys,
So i've finally began restoring these old rusty forks for my CL360 build, and the internals of the fork seem to differ from whats provided in my Clymer manual. It seems there is some kind of rebound rod within the spring that threads into the top bolt along with a lock washer. From...
Hey guys, couple of questions for ya.
So the 360 motor rebuild is coming to a close and I have everything back where its supposed to be, except for two miscellaneous pieces that I cant figure out where they belong. One seems to be a thin silver thrust washer of some sort, and the other is...
Hey guys. First off I wanted to thank you all for all the great info I've gotten so far just lurking around on this site. Ive recently undertaken the task of building a cafe racer out of a '75 CL360 I found on the Craig. I'm in the middle of Painting/rebuilding the top end and I've run into...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.