Recent content by pandknz

any pictures?, I had thought of doing this to the original steel backing.

Re: Flying J CB550 Atomic #13 DONE! with Pictures June BOTM right here!!!!

I will be.................... :(

Money is back in the bank, still would have prefered the guides, its a shame you could not make it happen as I think you were onto a good thing, hence why I invested but your efforts will not be forgotten and that promissed ride up the sunshine coast of Qld still stands if you ever get to the...

Hi All, been a while since I've had a chance to get any work done on the bike Here is the old battery box cut up to use a an electrical box in orioginal position and in place I have also added a inner gaurd and seat pan that will act as splash gaurds fro the rear wheel, it has @ 1/4 "...

Re: FFJMOORE CB550 Atomic #13 Motor in looking good, where are you mounting your battery?

the $100 is not as bad as not having guides :(

Hi All, a bit of an update, have not done much as I've been busy with a new job I have nearly finished with mocking up the bike before I tear it down and get some colour on it. pics below

I LIKE THE BLACK, KEEPS IT CLEAN NICE WORK!

The position looks very close to where I have set mine up, when I sit on my bike and put my feet on the pegs I naturally lean forward over the tank and it puts the clip ons in a perfect position for my hands and the sole of my foot is at @ 45 deg, this is where the brake and gear shift should...

I would rather see the bike with one of those mufflers on either side But 2-1 has better sound and Perfomance good looking bike so far, keep it up.

Any updates for us???? remember keeping us in the loop while waiting is ok, not knowing and left hanging is not.

Been trying to get one for a while but nobody will answer, I ended up getting a DTT original from Dime City, along with a few others

Still prepared to wait for mine, I'm at a very slow stage of the build, its too hot to get out in the shed.....26C low overnight here in brisbane at the moment and @ 38C during the day, the bike is turning into a winter project because I cant get near it 8) Keep us informed and wish all goes...

I was going to use my wiring until I pulled the old tape of and it feel apart in my hands, so now I will be doing a complete rewire, I have picked up a Reg/Rec from one of the small engines at work, its a Yanmar single cyl diesel and has a small alternator that charges a 9AH Battery, the Reg/Rec...